'Ballet' album
Violet Ballerina|362
times
59
Downloaded
Download
Make sure your stitches are not too tight. If you pull down the needle too tight, the stitches will look flat, and the Aida fabric may
be damaged.
Of course it is preferable to embroider in natural light: it puts less strain on your eyes, but it does not always work. So try to embroider closer to the lamp.
Try to plan the whole design in advance. Check that you have all the accessories. This is so annoying when the thread is over, when all the cross-stitch project is almost done.
be damaged.
Of course it is preferable to embroider in natural light: it puts less strain on your eyes, but it does not always work. So try to embroider closer to the lamp.
Try to plan the whole design in advance. Check that you have all the accessories. This is so annoying when the thread is over, when all the cross-stitch project is almost done.
Material Type: Aida Generic Black
Sewing Count: 14/inch or 55/100mm
Design Size: 77 x 109 stitches
Sewn Design Size: 5.5 x 7.8 inches or 140 x 198 mm
Suggested Material Size: 11.4 x 13.7 inches or 290 x 348 mm
Stitch Style: Cross-stitch Using 2 strands
Sewing Count: 14/inch or 55/100mm
Design Size: 77 x 109 stitches
Sewn Design Size: 5.5 x 7.8 inches or 140 x 198 mm
Suggested Material Size: 11.4 x 13.7 inches or 290 x 348 mm
Stitch Style: Cross-stitch Using 2 strands
DMC Threads
Cross Stitch Calculator
77 x 109 stitches 19 colors
Download
There are lots of different styles of embroidery hoops and frames available. Whether you use one or not is up to you. Beginning stitchers may find it easier to put their fabric in an embroidery hoop.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.