There are lots of different styles of embroidery hoops and frames available. Whether you use one or not is up to you. Beginning stitchers may find it easier to put their fabric in an embroidery hoop.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.
Material Type: Aida Generic White
Sewing Count: 14/inch or 55/100mm
Design Size: 84 x 100 stitches
Sewn Design Size: 6 x 7.1 inches or 152 x 181 mm
Suggested Material Size: 11.9 x 13 inches or 302 x 331 mm
Stitch Style: Cross-stitch Using 2 strands
The best way to do cross stitch is to do the first half of each stitch in a row done first then go back and finish the next half. This way you get all the stitches slanting in the same direction. It is very important that the slant is in the same direction for the top thread and the bottom thread of the cross stitch for all the stitches.
But there are expert cross stitchers who do individual cross stitches ( titching the full cross stitch as you go) and do a very good job of it. So each to his/ her own.
In order to be able to download you need to be logged in. If you still not registered you can do it now.