There are lots of different styles of embroidery hoops and frames available. Whether you use one or not is up to you. Beginning stitchers may find it easier to put their fabric in an embroidery hoop.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.
Material Type: Aida Generic White
Sewing Count: 14/inch or 55/100mm
Design Size: 62 x 83 stitches
Sewn Design Size: 4.4 x 5.9 inches or 113 x 151 mm
Suggested Material Size: 10.3 x 11.8 inches or 263 x 301 mm
Stitch Style: Cross-stitch Using 2 strands
Pick the color of floss you are starting with and cut a length about 18 inches long. If you go much longer than this, the thread is more likely to get knotted when you stitch.
Most embroidery floss is made up of six strands of thread twisted together. Depending on the fabric you are using, you will typically stitch with only one or two strands at a time.
To separate out a strand, hold the floss with one hand and pinch the end of one strand with the other. Gently and slowly pull the strand up and out until it is separated from the remaining strands. Only pull one strand at a time. Pulling multiple strands may cause the floss to knot.
In order to be able to download you need to be logged in. If you still not registered you can do it now.