Tension in your stitching is by far the easiest thing to correct, especially if you’re using a hoop – pull tight but not so tight that you stretch the hole at all. If you stitch in hand you have to be more careful.
I find that pulling the thread mostly through and then using my little finger in the hand holding the needle to “flick” the tail the final bit gives perfect tension and is reproducible for each stitch. Pay attention to the tension you’re applying as, if you stitch in different directions or do “patches” of stitching over the piece, you’ll pull it in weird directions.
Material Type: Aida Generic White
Sewing Count: 14/inch or 55/100mm
Design Size: 145 x 119 stitches
Sewn Design Size: 10.4 x 8.5 inches or 263 x 216 mm
Suggested Material Size: 16.3 x 14.4 inches or 413 x 366 mm
Stitch Style: Cross-stitch Using 2 strands
Cross stitch is typically done using a round-end tapestry needle. The size you use depends on your fabric. If you are stitching a kit, use the needle that came with it. If not, see this article on choosing a needle for cross stitch.
Thread your needle just as you would a needle for hand sewing. Don’t make a knot in the tail end. You will stitch over the tail as you work to secure it without needing a knot. As a general rule, you want to avoid using knots when cross stitching because they can leave lumps in the final piece.
In order to be able to download you need to be logged in. If you still not registered you can do it now.