Tension in your stitching is by far the easiest thing to correct, especially if you’re using a hoop – pull tight but not so tight that you stretch the hole at all. If you stitch in hand you have to be more careful.
I find that pulling the thread mostly through and then using my little finger in the hand holding the needle to “flick” the tail the final bit gives perfect tension and is reproducible for each stitch. Pay attention to the tension you’re applying as, if you stitch in different directions or do “patches” of stitching over the piece, you’ll pull it in weird directions.
Material Type: Aida Generic White
Sewing Count: 14/inch or 55/100mm
Design Size: 75 x 169 stitches
Sewn Design Size: 5.4 x 12.1 inches or 136 x 307 mm
Suggested Material Size: 11.3 x 18 inches or 286 x 457 mm
Stitch Style: Cross-stitch Using 2 strands
The fabric you use for any design should always be at least 2" longer on all sides beyond the design area. This helps hold the fabric in the hoop or q-snap when you are stitching, and also allows you to stretch the piece for finishing.
In order to be able to download you need to be logged in. If you still not registered you can do it now.