'Paintings' album
Little Beggar ( Bouguereau|2230
times
151
Downloaded
Download
Most designs supposed to be done using two strands of embroidery floss. But the floss is usually sold in six strand packaging.
So before threading your needle, you should separate all the 6 strands.
To do it just cut somewhat about 15”-18” (35 - 45 cm) of the thread. Hold it near the top with one hand allowing the bottom to untwist. Now pull each ply upward with the other hand. Carefully - one at a time.
Combine the necessary number of strands (typically two) and save the remaining for the next usage.
So before threading your needle, you should separate all the 6 strands.
To do it just cut somewhat about 15”-18” (35 - 45 cm) of the thread. Hold it near the top with one hand allowing the bottom to untwist. Now pull each ply upward with the other hand. Carefully - one at a time.
Combine the necessary number of strands (typically two) and save the remaining for the next usage.
Material Type: Aida Generic White
Sewing Count: 14/inch or 55/100mm
Design Size: 207 x 367 stitches
Sewn Design Size: 14.8 x 26.2 inches or 376 x 666 mm
Suggested Material Size: 20.7 x 32.1 inches or 526 x 816 mm
Stitch Style: Cross-stitch Using 2 strands
Sewing Count: 14/inch or 55/100mm
Design Size: 207 x 367 stitches
Sewn Design Size: 14.8 x 26.2 inches or 376 x 666 mm
Suggested Material Size: 20.7 x 32.1 inches or 526 x 816 mm
Stitch Style: Cross-stitch Using 2 strands
DMC Threads
Cross Stitch Calculator
207 x 367 stitches 50 colors
Download
There are lots of different styles of embroidery hoops and frames available. Whether you use one or not is up to you. Beginning stitchers may find it easier to put their fabric in an embroidery hoop.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.