Tension in your stitching is by far the easiest thing to correct, especially if you’re using a hoop – pull tight but not so tight that you stretch the hole at all. If you stitch in hand you have to be more careful.
I find that pulling the thread mostly through and then using my little finger in the hand holding the needle to “flick” the tail the final bit gives perfect tension and is reproducible for each stitch. Pay attention to the tension you’re applying as, if you stitch in different directions or do “patches” of stitching over the piece, you’ll pull it in weird directions.
Material Type: Aida Generic White
Sewing Count: 14/inch or 55/100mm
Design Size: 240 x 240 stitches
Sewn Design Size: 17.1 x 17.1 inches or 435 x 435 mm
Suggested Material Size: 23 x 23 inches or 585 x 585 mm
Stitch Style: Cross-stitch Using 2 strands
Most designs supposed to be done using two strands of embroidery floss. But the floss is usually sold in six strand packaging.
So before threading your needle, you should separate all the 6 strands.
To do it just cut somewhat about 15”-18” (35 - 45 cm) of the thread. Hold it near the top with one hand allowing the bottom to untwist. Now pull each ply upward with the other hand. Carefully - one at a time.
Combine the necessary number of strands (typically two) and save the remaining for the next usage.
In order to be able to download you need to be logged in. If you still not registered you can do it now.