'Dogs' album
Dog|4010
times
106
Downloaded
Download
Tension in your stitching is by far the easiest thing to correct, especially if you’re using a hoop – pull tight but not so tight that you stretch the hole at all. If you stitch in hand you have to be more careful.
I find that pulling the thread mostly through and then using my little finger in the hand holding the needle to “flick” the tail the final bit gives perfect tension and is reproducible for each stitch. Pay attention to the tension you’re applying as, if you stitch in different directions or do “patches” of stitching over the piece, you’ll pull it in weird directions.
I find that pulling the thread mostly through and then using my little finger in the hand holding the needle to “flick” the tail the final bit gives perfect tension and is reproducible for each stitch. Pay attention to the tension you’re applying as, if you stitch in different directions or do “patches” of stitching over the piece, you’ll pull it in weird directions.
Material Type: Aida Generic White
Sewing Count: 14/inch or 55/100mm
Design Size: 33 x 29 stitches
Sewn Design Size: 2.4 x 2.1 inches or 60 x 53 mm
Suggested Material Size: 8.3 x 8 inches or 210 x 203 mm
Stitch Style: Cross-stitch Using 2 strands
Sewing Count: 14/inch or 55/100mm
Design Size: 33 x 29 stitches
Sewn Design Size: 2.4 x 2.1 inches or 60 x 53 mm
Suggested Material Size: 8.3 x 8 inches or 210 x 203 mm
Stitch Style: Cross-stitch Using 2 strands
DMC Threads
Cross Stitch Calculator
33 x 29 stitches 7 colors
Download
There are lots of different styles of embroidery hoops and frames available. Whether you use one or not is up to you. Beginning stitchers may find it easier to put their fabric in an embroidery hoop.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.
To use a hoop, first loosen the screw and separate the two rounds. Place the round without the screw flat on a table or work surface. Lay the fabric over the hoop making sure the center of the fabric is in the center of the hoop. Place the other round over the fabric and press it down so the fabric is sandwiched between the two hoops. Gently pull the fabric taut as you tighten the screw on the hoop. Don’t pull the fabric too tight or it will distort the weave of the fabric.